If you simply bought a home entertainment system or a set of speakers, you may need some recommendations on properly configuring it in the event that you don’t desire to hire an installer. You might think you are technically savvy and that installing your brand-new home theater system would have been a snap. I can give some recommendations that can help you avoid some commonly made mistakes.
After unpacking your brand-new home theater system, you will usually find one central component in addition to 5 or 7 speakers 音響店. The central component is going to supply the audio for your entire speakers which you are going to set up. This central component is also called surround sound receiver or amplifier. It’s the central hub of your property theater system.
Make sure that you add this receiver in a location that’s fairly centrally located to minimize the total amount of speaker wire that you need to run. You don’t necessarily need to place the receiver right next to your TV. Just make certain it’s in a dry and safe place. Also, make certain that it is simple to reach the receiver from your own TV or DVD/Blue-ray player since you should connect these.
Connecting the receiver to power and to your TV or DVD is fairly straightforward. Modern TVs have a visual output which connects straight to your receiver with a fiberoptical cable. This cable might not be incorporated with your system but it can be acquired at any electronics store. However, creating your speakers can be a little more tricky.
If you have wireless rear speakers you won’t need the maximum amount of speaker cable and the setup is likely to be somewhat easier. First of all, measure how much speaker cable you’ll need. Be sure to add some extra cable to consider those bends and corners. Select the gauge of the speaker cable depending how much power you would like to drive your speakers with. The bigger the energy the thicker the speaker cable. Your subwoofer will usually have a built-in amp and hook up to your receiver via RCA cable.
When connecting the speaker cable, make certain that you connect the cable with the right polarity. Each speaker has a color coded terminal, usually red and black. Choose a speaker cable that shows one strand in an alternative color compared to other. Then connect the cable to all speakers the same way. Then, when connecting the speaker cable to your receiver, make sure that you connect the cable to each speaker terminal at the receiver in the same manner. This may keep carefully the sound likely to each speaker in the correct phase and optimize your sound experience.
Wireless rear speakers will typically incur an audio delay during transmission. This delay is also called latency. Typically the latency ranges between 1 and 20 ms. For optimum effect, it is most beneficial if every one of the speakers are in sync. If you have a method that uses wireless rears and wired front speakers, i.e. you’ve a variety of wireless and wired speakers, you must make an effort to delay the audio likely to the wired speakers by the latency of the wireless speakers.
Check with producer if your surround receiver can be set to delay the audio of specific channels. If you are using wireless rears, you want to set the front-speaker and side-speaker channels to delay the audio. Home entertainment systems which were not designed for wireless rear speakers may not have this capability. In cases like this you may want to locate a wireless speaker kit that has very low latency, ideally significantly less than 1 ms. This may keep your entire speakers in perfect sync.